Manufacturer: Paslode
Model: 900600
Rating: 
(53 reviews)
| List Price: Offer Price: $299.00 |
|
Features:
- 1-1/4-inch to 2-1/2-inch cordless 16-gauge gas angled finish nailer with non-mar tip and sight lines
- Depth-of-drive wheel with probe position indicator; locks tool at 10 nails to prevent blank firing
- Comfortable “sure grip” and soft trigger
- Includes nailer, battery, 2-hour charger
- 11-1/2 by 10-3/4 by 3-1/4 inches; 4.9 pounds with battery; 5-year warranty
Product Description
Paslode IM250A, 2-1/2″, Angled, Cordless, Finish Nailer, Drives 1-1/4″ To 2-1/2″, 16 Gauge, No Hose Or Compressor Required, 1 Year Warranty.
Amazon.com Review
Perfect for finish and trim work that requires getting into small spaces, this Impulse finish nailer from Paslode lets you avoid the hassle of compressor hoses and compressor noise. The nailer’s small, lightweight body (just under 5 pounds) is easy to grip and, because you’re not hooked up to a hose, doesn’t cause as much arm fatigue as other nailers. It drives 1-1/4- to 2-1/2-inch nails and has easy-to-adjust drive depth, a probe position indicator, and an angled clip for improved maneuverability. This Paslode nailer uses a patented system that requires both a fuel cell and an included rechargeable battery. We were impressed with the gun’s performance–it’s consistent and provides plenty of power for most uses. This model will shoot up to 1,200 nails on a single fuel cell and up to 4,000 nails on a full battery charge. It has a convenient belt hanger, too, so you won’t have to lay it on the ground or on top of a ladder, and the high-visibility orange makes it difficult to overlook. The kit includes a plastic carrying case and a lightweight charger. Please note that the nailer does not come with the fuel cell included. –Jonathon Tudor
Similar Products:
- B & C Eagle AF16X2 2-Inch by 16 Gauge by 20 Degree Angled Finish Nail (2,000 per Box)
- B & C Eagle AF16X212 2-1/2-Inch by 16 Gauge by 20 Degree Angled Finish Nail (2,000 per Box)
- B & C Eagle AF16X114 1-1/4-Inch by 16 Gauge by 20 Degree Angled Finish Nail (2,000 per Box)
- B & C Eagle AF16X112 1-1/2-Inch by 16 Gauge by 20 Degree Angled Finish Nail (2,000 per Box)
- Paslode Short Yellow Fuel Cell Pack #650039 for the Paslode Cordless Trim Nailers
5 Comments
There is no substitute for the angled pasload BUT it must be kept CLEAN
in order for it to not have problems like any other tool it must be kept clean I cant stress that enough. Avoid putting it on the ground. hang on a latter put it on a table Who wants to constantly bend over anyway????
Mike Carpenters Local 8
Bought the Paslode Framing and had such success on the job with it, i considered the finish nailer. Thinking that the finish nailer would be great so taht you are not dragging dirty houses through a home, i read the reviews on amazon and was amazed at the number of poor reviews. However, i went for it and just like the framer, this gun has performed flawlessly. Make good contact with the workpiece and it is as simple as that. Highly recommended!
All the same problems everyone else has had, except after my Paslode refurbishment it began shooting nails out of the bottom of the nail holder (about an inch from the tip of the gun). This is not good at all. I had high hopes for this tool and I really wanted it to work.
Works very well, even in hard woods. I trimmed a whole house and didn’t have one issue with it. Great product!
I have tried to get cutomer service to assit me for over one year. The company wants to sell the product, however, if you have a problem with your item the company has zero support after the sale. I will never buy or recommend to any one, any product that Paslode sells. If you spend hundreds of dollars and you get a defective item, no help is available after the sale. The techs that have looked at my nail gun can’t figure out why it works for 5 minutes ,then the next time you go to use the gun it will not work. So, before you lose alot of Dollars, buy another product that will have customer support after the sale.